Air Compressor
Loading content
Skip to main content

Does an oil-injected rotary screw air compressor use splash lubrication?

Key conclusion: Lubrication is not by splash but by pressurized oil injection.

Oil-injected rotary screw air compressors do not use splash lubrication; their core lubrication mechanism isPressure oil spray lubricationThis design uses a dedicated oil supply circuit to inject lubricating oil at a controlled pressure directly into the rotor or vane compression chamber, where it participates in the working cycle in sync with the compressed air, thereby achieving efficient thermal management and mechanical protection.

The actual operating principle of the oil-injection lubrication system

During the operation of a rotary air compressor, lubricant is supplied by a dedicated oil pump rather than by mechanical centrifugal oil甩. The injected oil performs three critical functions within the compression chamber:

  • Dynamic sealingThe oil film fills the rotor meshing clearance and the housing gap, blocking the high-pressure gas backflow path and maintaining high volumetric efficiency.
  • Forced cooling: The air compression process releases a large amount of heat, which is rapidly absorbed by the injected oil, effectively preventing an abnormal rise in exhaust temperature.
  • Fluid lubricationThe lubricant coats the driving and driven bearings, the rotor journal, and the sliding contact surfaces, forming a stable oil film that reduces the coefficient of friction between metal surfaces.

The fundamental difference from splash lubrication

Splash lubrication is commonly used in low-speed reciprocating compressors or conventional gearboxes, relying on the crankshaft or gears dipping into the oil sump and throwing oil as they rotate. Rotary air compressors, due to their high speed, large compression ratios, and concentrated heat generation, cannot achieve adequate cooling or sealing precision through splash lubrication alone. The main differences between the two are as follows:

  • Fuel supply power: Splashing relies on the centrifugal force generated by the rotation of the component; oil injection relies on forced pressurization and delivery by a hydraulic pump.
  • Area of effect: Splashing covers only the exposed components above the oil tank; oil injection directly enters the compression core cavity.
  • Control accuracy: The amount of splash lubrication is greatly affected by rotational speed and oil level fluctuations; the oil spray flow rate can be precisely adjusted via a thermostatic valve and an orifice.

System Circulation Architecture and Maintenance Key Points

Oil-injection lubrication is a closed-loop system; after completing the compression process, the oil–gas mixture must pass through a separator to recover the lubricant, then undergo multi-stage filtration before being reinjected into the compressor. Daily operations and maintenance should focus on the following aspects:

  • Replace the dedicated compressor oil and precision filters according to operating time to prevent gum deposits from clogging the fuel injectors or contaminating the separator element.
  • Regularly check the opening and closing response of the thermostatic valve to ensure that the lubricating oil viscosity remains within the manufacturer’s recommended range, thereby preventing excessive starting resistance at low temperatures or accelerated oxidation at high temperatures.
  • Monitor the differential pressure of the oil–gas separator and the condition of the oil return line; poor oil return can trigger an oil starvation alarm on the main engine and even cause bearing damage.

Accurately distinguishing the technical boundaries between oil‑injection lubrication and splash lubrication helps operators establish proper inspection standards and scientifically schedule oil‑change intervals, thereby ensuring the long-term, stable air supply of rotary air compressors.

Share to

share

There are no comments yet. Be the first to comment!

Post a new comment

Comment content will be automatically filtered for XSS security vulnerabilities.
Basic HTML tags are available, including: bold, italic, code, quotes, links, etc.