Ambient temperature and air humidity are too high.
If the air drawn into an air compressor is hot and humid, its initial moisture content will increase significantly. Although compression does not directly produce water, it forces ambient water vapor into the system. As temperatures rise or during the rainy season, the absolute humidity of the atmosphere increases, leading to a greater total amount of water vapor entering the compression chamber and creating conditions that can result in condensate formation downstream.
Cooling system performance has decreased.
The compressed high-temperature gas must be effectively cooled to allow most of the water vapor to condense and separate. If the cooler’s surface is fouled or blocked, the circulating water flow is insufficient, or the cooling fan fails, the exhaust temperature cannot be reduced to the set range. Elevated temperatures raise the dew point, preventing substantial moisture from condensing beforehand and causing it to enter downstream piping and gas‑using equipment directly.
Drying and Automatic Drainage Unit Malfunction
The key to air‑source treatment lies in the dehumidification stage. Insufficient refrigerant pressure or frost buildup on the heat exchanger in refrigerated dryers, or moisture‑induced caking of the desiccant and malfunctioning switching valves in adsorption dryers, can all severely reduce dehydration efficiency. Meanwhile, if the automatic drain valve at the bottom of the air receiver or filter seizes, the timer is set incorrectly, or the filter bowl is damaged, condensate cannot be discharged promptly, leading to secondary re‑moistening.
Omissions in Piping Layout and Routine Maintenance
If the main pipeline does not maintain a proper slope or lacks low-point drainage design, condensate can accumulate at the bottom of the pipe and be carried by the airflow, resulting in water pooling. Incorrect connections on branch lines can also route accumulated water at the bottom directly into the terminal equipment. Furthermore, prolonged use of precision filter elements beyond their service life and aging seals that leak air can both compromise the original drying performance, causing outlet water quality parameters to repeatedly exceed standards.
The equipment has been operating under overload for an extended period.
When actual gas consumption continuously exceeds the air compressor’s rated discharge capacity, system pressure fluctuates frequently and loading times become excessively long. Operating under overload not only exacerbates unit temperature rise but also shortens cooling cycles and reduces overall heat exchange efficiency. It is recommended to optimize operating conditions through the following measures:
- Matching gas demand: Regularly calculate peak traffic to prevent underpowered servers from handling excessive loads.
- Optimized Start-Stop Control: Employ variable-frequency or multi-unit coordinated control strategies to reduce no-load operation and frequent loading/unloading.
- Increase the frequency of inspectionsFocus on exhaust temperature, oil separator differential pressure, and operating parameters of aftertreatment devices.
Consequently, the processing capacity of the air‑source treatment equipment is diluted, ultimately resulting in persistently high relative humidity at the outlet.
There are no comments yet. Be the first to comment!